Speedway Motors Electric Emergency Parking Brake Kit with Cables and Brackets Universal Push Button Electronic E-Brake Actuator for Disc or Drum Brake Systems

Electronic actuator can be mounted to body or frame and is weatherproof. Up to 600 lbs. of cable pull strength actuates most any drum or disc parking brake. Single button control to engage and disengage brake function. Controller uses no power and does not drain battery when brake is set. Three inches total cable pull length engages most any parking brake setup. Simple wiring direct to battery positive and negative and ignition switch. Optional wire to power "parking brake engaged" warning light on dash. 10-gauge steel cable junction bracket for parking brake cables. 108-inch overall length universal parking brake cables fits most vehicle applications. Parking brake cable mounting hardware included. Hardware to mount junction bracket and electronic actuator not included. Adapters for Wilwood and Ford Explorer-based rear disc kits included. Complete and safe Emergency Brake Function for Any Vehicle While the use of a parking brake or emergency brake as some people refer to them as has been in use for over 100 years of automobile production now when it comes to custom vehicles that have been modified it isn't often easy to incorporate usable parking brake functionality. For some vehicles there is little to no room for an under-dash parking brake pedal mount. Same goes for a small car like a '32 Ford or a T-bucket with a bench seat and trying to utilize some sort of transmission tunnel mounted pull handle. For others it could be the conversion from factory drum brakes to rear disc brakes or the use of a custom frame mini-tubbing a car or any other modifications where the factory cable mounting brackets and cable path may no longer be an option. The solution to all of this? A conversion using our universal electric parking brake kit. Much like the electric parking brake (often called an EPB) found in newer vehicles the electric parking brake conversion kit features a simple on/off control using a push button to engage and disengage the system. Overall it is an easy system to work into a custom vehicle build is universal in nature so it will work on any hot rod muscle car or classic truck (and most any drum or disc parking brake setup) can be frame or body mounted out of the way and the activation button can be dash mounted or mounted in a discreet location to double as a security system. We've packaged the E-Stopp electronic parking brake system along with a cable junction bracket and a universal parking brake cable kit to provide everything you need for full parking brake functionality that will hold any vehicle safely and pass any state vehicle inspection that requires a functioning parking brake. Simple To Use Electric Emergency Brake System with Pushbutton Activation The E-Stopp electric emergency brake system a NSRA new safety product of the year award winner uses a pushbutton activated controller to apply and release your disc or drum parking brake setup. This pushbutton visually confirms activation by blinking as the brake is applied or released. The button is a latching type meaning when you push to activate the button latches holding the button in. Pushing the button to release the brake unlatches the button allowing it to be flush with the mounting ring again. While not a physical part of the button there is a speaker module included that beeps during activation of the pushbutton to audibly denote the application or release of the parking brake system. The button requires a single 7/8-inch hole to be drilled and the button has a detachable cable allowing the button to be fitted from the front of the panel for a clean look. Rugged and Waterproof Actuator Assembly Mounts Almost Anywhere The included linear actuator assembly is weatherproof and can be mounted under the vehicle where it can be exposed to wet conditions without issue